[jackpot554]

You'll have to change the driveshaft with a new custom shaft to take a 1350 even if it does fit the t-case... At that point it will likely come with a new slip yoke anyway. Just saying...

Thanks Surf, I already have a yoke that takes a 1350 on my rear diff. My D-shaft has a 1350 and a 1330, the 1330 yoke on the shaft (the one for the T-case) got damaged and they need to fix it anyway so I asked them to look if they could put a 1350 instead, That's why Im asking if the Titan yoke will fit.

 

[jackpot554]

All the specs match between the two except for the u-joint. I say go for it in your situation if you can find one in stock.

The only difference I see is

1.401" = APPROX INTERNAL SPLINE MAJOR DIAMETER for an Xterra

and

1.406" = INTERNAL SPLINE MAJOR DIAMETER for a Titan

but they say APPROX for the Xterra

 

[jackpot554]

Had a confirmation from the Drive shaft shop that it will fit so Im going this way, I'll confirm the part number of the 1350 Titan yoke when I get the invoice.

 

[jackpot554]

So the Titan yoke fits no problem on the T-case, I installed it. The yoke on the Diff is a 1 ton GM yoke, I think it only fits on the 2005 and 2006 model thou. There is a place on this forum where they talk about it, I think it was from Greg at PRG.