Second Generation Nissan Xterra Forums banner

Slider dimensions please

2396 Views 5 Replies 5 Participants Last post by  RockyMtnX
1) Face of frame mounting bracket to back side of 2x2 tube: ?
-Is it the same front and rear?
2) Front edge of slider to perpendicular 2x2 frame support/bracket: ?
3) Rear edge of slider to perpendicular 2x2 frame support/bracket: ?

Thanks guys!
1 - 6 of 6 Posts
RockyMtnX said:
1) Face of frame mounting bracket to back side of 2x2 tube: ?
-Is it the same front and rear?
2) Front edge of slider to perpendicular 2x2 frame support/bracket: ?
3) Rear edge of slider to perpendicular 2x2 frame support/bracket: ?

Thanks guys!
If you are asking about Shrockworks sliders, then shouldn't you have posted this in the Shrockworks forum, and if you are asking the question of anyone who has sliders, no matter what the brand, maybe you should make that clear? Either way, I can't help, because mine haven't been ordered yet.
dpatton,

Your sentences make me feel drunk.
________
Mercedes-benz om615 history
Syndicate said:
dpatton,

Your sentences make me feel drunk.
X2.

I had to take a look again to see what forum I was in. It's in the Exterior unless Greg moved it.
- :clown: Yo Rocky--

--these guys are just being hard on you-I'll give you those measurements, exactly as you asked--


-
RockyMtnX said:
1) Face of frame mounting bracket to back side of 2x2 tube: ?
-Is it the same front and rear?
2) Front edge of slider to perpendicular 2x2 frame support/bracket: ?
3) Rear edge of slider to perpendicular 2x2 frame support/bracket: ?

Thanks guys!
--1)--6 5/8" and same front and back

--2)--16 1/2 "

--3)--6 3/4"

-- :geek: :geek: --JIMBO
See less See more
Thanks; I appreciate it, JIMBO!
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top