[aaron_mallory1]

I recently got 1/2" spacers to fit a set of wheels onto my second generation Xterra. With the type of wheels I have and the spacers, the lug bolts are not long enough to screw the lug nuts on. What length are the stock bolts?

 

[jeromy6]

I recently got 1/2" spacers to fit a set of wheels onto my second generation Xterra. With the type of wheels I have and the spacers, the lug bolts are not long enough to screw the lug nuts on. What length are the stock bolts?

Stock lugs are 12x1.25. I am running wheel adapters that bolt to the hub, then the wheel bolts to the adapter. For this setup I use 12x1.25 open end extended thread nuts because you wouldn't be able to see them under the rim. It sounds like you are just using a spacer behind the rim, so extended 12x1.25 capped nuts are probably what you are looking for. It's been a while, but I am pretty sure they are 12x1.25. I will dig up an old link and repost.

Check out this link:

Black ET Conical Bulge Lug Nut 12x1.25 Long

ezAccessory, Reliable Wheel Accessory for lug nuts, wheel spacers, wheel adapters, lug bolts, wheel locks, hub centric rings, valve stems

www.ezaccessory.com

 

[jeromy6]

Check out this thread, page 2 covers the 12x1.25 OE size (looks like I had a similar question 10 years ago). You probably may still want to get the ET if you are just adding a spacer and not an adapter, as mentioned above.

Wheel Spacer Question!

Hey guys, i figured out that i wanna put 1.5" wheel spacers on my X, just for a more aggressive look. So the question i have is, if the tire is brought 1.5" outwards on the rear end, will it hit the fender when it is under load?. because i know that the front end will articulate the tire on an...

www.thenewx.org