Hey Mike
I installed the 75 WX ST in my X. I have the the box under the Shifter. ( I didn't like the way it mounted under the cup holder.
The hand held is mounted to the left of the 4x4 shift switch. ( Already scratched up from those stupid metal clips in the dash. So no big deal putting 2 screws to hold the hand held clip.)
I ran an 18' coax from the shift area under the center console towards the back. then went under the carpet and along the Pas. Side and behind the side panel in the rear of the X. ( Panel where the rear pockets are.) Then drilled a hole the size of the coax Plug behind the Pas. Side tail light. ( Used a rubber grommet to seal and protect the cable from the metal edges of the hole.) Then the cable goes down behind the bumper cap and over to the Shrock bumper hole ( where the wire comes thru for the plate light on the swingaway.)
Side note - You can also mount the antenna to the side of the rear tailgate. This is the way John ( Creek ) mounted his and it holds up pretty well.
I'll have to take some pics tomorrow so you can see how I did it.
The down side is I'm having problems dialing in the CB with the SWR Meters. Stupid things don't come with instructions.
Time to find a CB shop to have them tune it.
I installed the 75 WX ST in my X. I have the the box under the Shifter. ( I didn't like the way it mounted under the cup holder.
The hand held is mounted to the left of the 4x4 shift switch. ( Already scratched up from those stupid metal clips in the dash. So no big deal putting 2 screws to hold the hand held clip.)
I ran an 18' coax from the shift area under the center console towards the back. then went under the carpet and along the Pas. Side and behind the side panel in the rear of the X. ( Panel where the rear pockets are.) Then drilled a hole the size of the coax Plug behind the Pas. Side tail light. ( Used a rubber grommet to seal and protect the cable from the metal edges of the hole.) Then the cable goes down behind the bumper cap and over to the Shrock bumper hole ( where the wire comes thru for the plate light on the swingaway.)
Side note - You can also mount the antenna to the side of the rear tailgate. This is the way John ( Creek ) mounted his and it holds up pretty well.
I'll have to take some pics tomorrow so you can see how I did it.
The down side is I'm having problems dialing in the CB with the SWR Meters. Stupid things don't come with instructions.
Time to find a CB shop to have them tune it.