Second Generation Nissan Xterra Forums (2005+) - View Single Post - Front Sway Bar - Articulation Question ?
View Single Post
post #21 of (permalink) Old 05-07-2019, 02:46 PM Thread Starter
X4dblduty
Senior Member
2006 Granite Xterra Off Road
 
X4dblduty's Avatar
 
Join Date: Nov 2015
Location: Chino Hills, CA
Posts: 183
Garage
I'll be removing my FSB soon. Another question related to travel since now freed up from the FSB removal. Is anyone running the SPC Radflo Eibach 600lb coilover kit WITH any added small spacer, like 1"? My coil bucket has been shaved, so no CBC worries, but what about CV bind at full droop?

Need just a bit more clearance. Thanks guys, again....

EDIT: Just talked to Greg at PRG since I got the Advanced kit from him. His recommendation since each truck is slightly different in susp tolerances plus these kits were made with safe allowances for longevity, is to measure:

a) jack up and remove front tire
b) remove lower shock bolt and let susp droop fully, make sure nothing is binding (coil bucket, FSB)
c) turn the axle MANUALLY until you feel the cv starting to bind, then come up 1/2", cv should be smooth again when turning the axle.
d) measure the shock mount on LCA to the shock bolt hole.
e) this measurement to give them the proper 'safe' spacer sizing to use. Per Greg he can make any spacer with this measurement.

Hope this helps. Don't just guess on what will work since each truck can be a little different.

Hey I'm also not responsible for any miscalculations here, measure yourself.

Last edited by X4dblduty; 05-07-2019 at 03:29 PM.
X4dblduty is offline  
 
 
For the best viewing experience please update your browser to Google Chrome